2 Pin Male Female Crank Sensor Waterproof Wire Connector 7282-7023-10 7283-7023-10 for Lexus Toyota Reiz

2-Pin Waterproof Crankshaft Position Sensor Connector — 7282-7023-10 / 7283-7023-10 for Toyota Lexus Reiz

OEM-compatible 2-pin waterproof connector for crankshaft position (CKP) sensor wiring harnesses on Toyota Reiz, Lexus, and related platforms. This connector matches Yazaki OEM part numbers 7282-7023-10 (male plug) and 7283-7023-10 (female socket), also referenced as DJ7025C-2.2-11/21, and is used in crankshaft and camshaft position sensor circuits critical for engine timing and ignition control.

Specifications

• OEM Part Numbers: 7282-7023-10 (male) / 7283-7023-10 (female)
• Also Referenced As: DJ7025C-2.2-11 (male) / DJ7025C-2.2-21 (female)
• Standard: Yazaki 2.2mm series
• Pin Count: 2-pin
• Terminal Pitch: 2.2mm
• Housing Material: PA66 nylon (high-temperature, flame-retardant)
• Terminal Material: Brass with tin plating
• Seal: Individual rubber wire seals (IP67 waterproof)
• Wire Gauge: Compatible with 0.3–0.85mm² (AWG 22–18)
• Certification: CE

Available Variants

• Male set — 1 × male housing + 2 × terminals + 2 × rubber seals
• Female set — 1 × female housing + 2 × terminals + 2 × rubber seals
• Male + Female set — both housings + 4 × terminals + 4 × rubber seals
• 15cm wire (male) — pre-assembled male connector with 15cm wire leads
• 15cm wire (female) — pre-assembled female connector with 15cm wire leads

Compatible Vehicles

• Toyota Reiz (crankshaft position sensor)
• Lexus vehicles using Yazaki 7282/7283-7023-10 connector
• Applications using DJ7025C-2.2 connector standard

Why Crankshaft Sensor Connector Replacement Matters

A corroded or damaged CKP sensor connector causes intermittent or complete loss of crankshaft position signal, resulting in hard starting, misfires, stalling, or no-start conditions. Replacing the connector restores the OEM-spec waterproof seal and low-resistance contact, eliminating signal dropouts without replacing the sensor itself.

Installation Notes

• Requires automotive crimping tool for 2.2mm terminals (Engineer PA-09 or equivalent)
• Install rubber seal on wire before crimping terminal
• Push terminal into housing until audible click confirms locking
• Pre-wired variants can be spliced directly using heat shrink solder butt connectors

Package Contents

• Connector set as selected (housing + terminals + seals, or pre-wired 15cm harness)

Enjoy free standard shipping on all orders over $199 USD. Orders are processed within 1–2 business days.

Not satisfied? Return any item within 90 days of purchase for a full refund or exchange. Items must be in original condition.

We are committed to quality, reliability, and customer satisfaction. Every product is carefully selected and tested to meet the highest standards.