Black Nylon U/R-Shape Cable Clamp Clip — UV Resistant Wire & Hose Loop Holder

Black Nylon U/R-Shape Cable Clamp Clip — UV Resistant Wire & Hose Loop Holder

These black nylon U/R-shape cable clamp clips provide a clean, secure mounting solution for routing and securing wires, cables, hoses, and conduit along panels, frames, and bulkheads. Made from UV-resistant nylon, they withstand prolonged outdoor and engine bay exposure without becoming brittle or discoloring. A single screw through the center hole mounts the clip to any flat surface, and the loop snaps closed around the cable or hose for a rattle-free hold.

Key Specifications

Why Choose Nylon Cable Clamps?

• UV-resistant PA66 — Stabilized nylon resists UV degradation, ozone, and temperature cycling; does not become brittle after years of outdoor or engine bay exposure
• Non-conductive — Nylon provides electrical isolation between the cable and the mounting surface, preventing galvanic corrosion and short circuits
• Screw-mount security — Single-screw mounting is more secure than adhesive-backed clips; will not peel off in heat or moisture
• Snap-close loop — Cable or hose snaps into the loop without tools; remove and reposition as needed
• Multiple sizes — Select the clip diameter that matches your cable or hose OD for a snug, rattle-free fit

Typical Applications

• Automotive engine bay wiring harness and fuel/brake line routing
• Marine bilge pump hose and electrical cable routing
• Industrial panel wiring and conduit support
• RV and caravan water pipe and electrical cable management
• Bicycle and motorcycle cable routing along frame tubes
• Home workshop air hose and power cable wall mounting

Frequently Asked Questions

Q: What screw size fits the mounting hole?

The center mounting hole typically accepts M4 or M5 screws (or #8 / #10 imperial screws) depending on the clip size. Check the variant description for the specific hole diameter. Use a stainless steel screw in outdoor or marine applications to prevent rust staining.

Q: Can these be used with hydraulic hoses?

Yes, for low-pressure hydraulic and pneumatic hoses. For high-pressure hydraulic lines (above 100 bar), use metal P-clamps with rubber lining rated for the specific pressure and vibration requirements of your application.

Package Contents

• Pack of black nylon U/R-shape cable clamp clips (size and quantity per selected variant)