Keszoox
3-Pin 0.6mm Camshaft Position Sensor Connector DJ7032W-0.6-21 with 15cm Wire
3-Pin 0.6mm Camshaft Position Sensor Connector DJ7032W-0.6-21 with 15cm Wire
Couldn't load pickup availability
3-Pin 0.6mm Camshaft Position Sensor Connector — DJ7032W-0.6-21 with 15cm Wire
OEM-compatible 3-pin 0.6mm pitch camshaft position sensor connector pre-assembled with 15cm wire pigtail leads. Ready-to-splice design eliminates the need for separate terminal crimping — simply strip and solder or use butt connectors to integrate into your existing harness.
Specifications
| Parameter | Value |
|---|---|
| Pin Count | 3 |
| Pitch | 0.6 mm |
| Part Number | DJ7032W-0.6-21 |
| Housing Material | PA66 (Nylon 66) |
| Sealing | Rubber wire seal (waterproof) |
| Wire Length | 15 cm (pre-wired pigtail) |
| Operating Temperature | -40°C to +125°C |
| Application | Camshaft position sensor, fuel injector plug |
| Certification | CE |
Compatible Applications
- Camshaft position sensor (CMP) connector repair on various Asian and European vehicles
- Fuel injector plug replacement where DJ7032W-0.6-21 housing is used
- Engine management harness repair requiring 0.6mm pitch 3-pin sealed connector
- Custom ECU wiring harness builds with pre-wired pigtail for clean integration
Why Choose This Connector?
- ✅ Pre-wired 15cm pigtail — no terminal crimping required, splice directly into harness
- ✅ 0.6mm ultra-compact pitch — fits tight sensor mounting locations
- ✅ Rubber wire seal — IP67-rated moisture protection for engine bay use
- ✅ PA66 housing — heat and oil resistant, rated to 125°C
- ✅ CE certified — meets EU automotive electrical standards
Application Scenarios
- Camshaft position sensor connector replacement during timing belt / chain service
- Injector plug repair on engines where 0.6mm pitch DJ-series connectors are used
- DIY engine harness restoration where original connector is damaged or corroded
- Motorsport harness build requiring compact sealed 3-pin sensor connections
FAQ
Q: Do I need to crimp terminals separately?
A: No. This connector comes pre-wired with 15cm leads already crimped and sealed. Simply splice the pigtail wires into your existing harness using butt connectors or solder + heat shrink.
Q: Is this connector compatible with camshaft and crankshaft sensors?
A: The DJ7032W-0.6-21 is primarily used for camshaft position sensors and fuel injector plugs. Verify the OEM part number on your sensor before ordering.
Q: What wire gauge are the pigtail leads?
A: The pre-wired leads are typically 0.35mm² (AWG 22), suitable for sensor signal and power circuits.
Package Contents
- 1× 3-Pin 0.6mm Connector (DJ7032W-0.6-21) with 15cm pre-wired pigtail leads
