Keszoox
DC Power Filter Board 0–50V EMI Suppression for Class D Amplifier
DC Power Filter Board 0–50V EMI Suppression for Class D Amplifier
Couldn't load pickup availability
DC Power Filter Board — 0–50V EMI Suppression for Class D Amplifier
This DC power filter board is designed to suppress switching noise, EMI, and power supply ripple in Class D amplifier systems. Using an LC filter topology with large bulk capacitors, it cleans the DC supply rail before it reaches the amplifier, reducing audible noise, hiss, and interference caused by switching power supplies and motor drives.
Key Specifications
| Parameter | Value |
|---|---|
| Input Voltage Range | 0V – 50V DC |
| Max Current | 10A–20A (depends on inductor rating) |
| Filter Topology | LC filter + bulk electrolytic capacitors |
| Capacitance | Large bulk capacitors (varies by board version) |
| EMI Suppression | Common-mode and differential-mode |
| Connector | Screw terminals (input/output) |
Why Use a DC Power Filter?
- Eliminates Switching Noise — SMPS switching artifacts (50kHz–500kHz) cause audible hiss in Class D amplifiers; LC filter attenuates these
- Reduces Ripple Voltage — Bulk capacitors absorb current demand spikes during audio transients
- Improves Audio SNR — Cleaner supply rail directly improves signal-to-noise ratio of the amplifier
- Protects Amplifier IC — Filters voltage spikes that can damage MOSFET gate drivers and output stages
- Wide Voltage Range — 0–50V covers 12V, 24V, 36V, and 48V Class D amplifier supplies
Typical Applications
- IRS2092S, TPA3116, TPA3255 Class D amplifier power supply filtering
- DC motor drive power supply noise suppression
- Switching power supply output ripple reduction
- Car audio amplifier power line filtering
- Industrial inverter DC bus noise suppression
Installation Guide
Connect SMPS output → filter board input terminals. Connect filter board output → amplifier power input. Ensure wire gauge matches maximum current rating. Mount filter board close to amplifier for shortest power path.
FAQ
Q: Does this filter board work with linear power supplies?
A: Yes — it further reduces residual ripple from linear supplies, though the improvement is less dramatic than with SMPS sources.
Q: What’s the maximum current this board can handle?
A: Depends on the onboard inductor rating — typically 10A–20A. Check the inductor markings on your specific board version.
Package Contents
- 1× DC Power Filter Board (0–50V, EMI suppression)
