The shipping fee depends on your address
Standard: 9-15 business days,fee is down to $3.99
Express: 4-7 business days,fee is down to $5.99
WE'RE READY TO BUILD A CUSTOM PRODUCT FOR YOU.
If you're looking for a custom product, we can help. Kindly contact us via email support@keszoox.com and send us the details for your need, then we'll let you know how we can deliver the right solution.We make into production usually Within 1 - 3 Bussiness Days.
Expect customization orders.8 – 40V input to 5V output
These modules are unique in that they combine both a DC-DC converter to accept a wide input voltage range coupled with an LDO linear regulator to provide a well regulated output.
The DC-DC input section can take a range of 8 to 40V on its input.
It uses the ME3116 switching regulator IC that operates at 550kHz and is configured to provide a fixed output voltage set to 6.3V. Efficiency of this section is 85-90%.
The 6.3V is then feed to an LDO 1117A-5 linear regulator. This regulator trims the 6.3V down to the final 5V output while also helping to filter the ripple and noise on the output of the DC-DC section. Efficiency of this section is 71-78% giving an overall efficiency of 60-70% for the module.
The final output has a ripple of 12-20mV under most conditions. It doesn’t remove it completely due to the tight circuit coupling between the DC-DC converter and linear sections on the small board. It is still 2-10x better than what most DC-DC converters can provide when used alone. Measurements were done with a 100uF bulk capacitor on the output.
Because the linear regulator is always dropping a minimal voltage amount, it can operate at its full 700mA current rating independent of the input voltage.
There is a 3-pin right angle header for making connections.
1 x 3 Header
These are handy modules that can help resolve some common problems related to trying to generate a fairly clean 5V from a relatively high input voltage without having to derate the output current based on the input voltage like when using a linear regulator alone.
We tested these over over the full range of 8 to 40V at 700mA load without any issues. At full load the module does run quite warm as expected.
The modules can handle up to 1A for short periods of time and we have tested to 800mA for extended periods at 25C ambient.
One quirk we have seen in our testing is that if the load is more than 600mA without any bulk capacitance on its output, the output can go into a current limit or other shutdown mode when power is first applied. We have only seen this when testing using electronic dummy loads. Add even a 10uF capacitor on the output resolves this, so it is not expected to be an issue under normal circuit conditions.
One thing to be aware of whenever using any breadboard friendly power module is that while the module may be able to handle 700+mA, the typical breadboard jumper wires will have a fairly significant voltage loss passing that much current. When using with higher current loads you may need to double-up on the wires or use heavier gauge wires on the output voltage connections to minimize the voltage drop.
Notes:
Maximum Ratings | ||
VIN | Input Voltage Range | 8 to 40V |
IO | Maximum Output Current | 700mA |
IPEAK | Peak Surge Current | 1000mA |
Operating Ratings | ||
VO | Output Voltage | 5V |
IO | Max Output Current (Continuous) | 700mA |
Iq | Quiescent current | 5mA typical |
Dimensions | L x W x H (not including header) | 25 x 16 x 5.8mm |
Country of Origin | China | |
Datasheets | SiiTek | ME3116 |
Representative datasheet | 1117-5 |
WE'RE READY TO BUILD A CUSTOM PRODUCT FOR YOU.
All orders are dispatched from our warehouse. The shipments are fully tracked—from our door to yours. Please allow 3-5 business days for your order to be processed in addition to the shipping times below.
Standard: 9-15 business days. Express: 4-7 business days.
Please note that shipping providers are extremely busy during this time, and some orders might experience a delay on top of usual delivery times. If your order is late, please allow 5-10 days more than indicated in standard shipping times before contacting our customer service. Thank you for your understanding.
All orders are 100% tracked. You’ll receive an email with a tracking number and a link to track your parcel once your order leaves our warehouse. Please allow 24-48 hours for the tracking link to start showing shipping information.
Receive our latest updates about our products & promotions.
Thanks for subscribing!
This email has been registered!