Relay Breakout Module 5V

5V logic compatible relay that can control up to 125/250VAC @ 10A  or up to 15VDC @ 10A.

DESCRIPTION

The Relay Breakout Module 5V is a logic compatible relay that can control up to 125/250VAC @ 10A  or up to 15VDC @ 10A.

PACKAGE INCLUDES:

• Relay Breakout Module 5V

KEY FEATURES OF RELAY BREAKOUT MODULE 5V:

• Switch AC up to 125/250VAC @ 10A
• Switch DC up to 15VDC @ 10A
• Normally Open (NO) and Normally Closed (NC) contacts
• LED indicator when relay is energized
• 5V logic compatible

Relay modules are handy for controlling external loads.  Unlike transistors used for switching, relays use metallic switch contacts which avoids the power loss and heating inherent in transistor switching circuits.  They are also  nicely contained little modules that are simple to hook-up and are especially useful for switching AC.  The main downside to relays is that being an electro-mechanical device, like any switch relays are more prone to wear and tear from prolonged use.

Module Control

These relays are fully 5V logic compatible. The input has a relay driver transistor built-in which means the device only needs about 5mA on the logic control pin to drive it.  If you have a uC like an Arduino, you can drive the relay using any of the digital output pins.

The relay is activated with a logic LOW signal.  There is a green LED that is lit when the control pin is driven low to activate the relay.  When the relay is activated an audible click will be heard.  A logic HIGH deactivates the relay and the LED will go off.

Module Power

The module requires 5V power and Gnd to operate.

At least the ground should be shared with the microcontroller.  There is a red LED that is lit when Vcc is applied to the module.  A flyback diode is included on the module in parallel to the relay coil to safely shunt current when the relay coil is de-energized.

When the relay is energized, the module draws about 80mA from the Vcc pin.

Relay Operation

The output of the relay is rated to switch up to 30VDC at 10A per the relay markings (see our notes below) or up to 125/250VAC at up to 10A.

The output is SPDT type with both a NO (Normally Open) terminal and a NC (Normally Closed) terminal relative to the center unmarked common (COM) terminal.  A logic LOW energizes the relay, so the NO–COM contact is closed and the NC-COM contact is open.  A logic HIGH or no input de-energizes the relay and the NO-COM contact is open and the NC-COM contact is closed.

Module Connections

There is a 3-pin header on the assembly for logic and power as well as 3 screw terminals for making connections to the relay contacts.

1 x 3 Header 

• ‘-‘ = Ground.  Must be in common with the uC
• ‘+’ = 5V
• S = Signal input.  Connects to digital output pin on uC

Relay Contacts

• NC = Normally Closed side of the relay
• Center Terminal = Common terminal usually connects to the power source
• NO = Normally Open side of the relay

OUR EVALUATION RESULTS:

These are nice little relay modules that will work for many power control applications.

We did find the DC rating of the relay to be too aggressive. With DC voltages above about 15V, the contacts can become a little sticky. If using it to switch DC voltages, I recommend limiting the voltage to 15V or lower.

With AC, the relays performed very well in our testing.  To test the upper limit we used it to switch a 1500W heater which drew about 12.5A which is greater than its rated current and the relay handled it without any problems for 10 power cycles.

BEFORE THEY ARE SHIPPED, THESE MODULES ARE:

• Sample inspected and tested per incoming shipment

Notes: 

1. This module is the same or similar to the KY-019

TECHNICAL SPECIFICATIONS